RHUB TM-510 Especificaciones descargar pdf (Pagina 255)

100

101

TM 9-2350-311-34-1

14 Unsolder electrical lead (45) from field coils (46) to connector (TB SIG 222).

15 Remove screw (47), Iockwasher (48), and field coils (46) from commutator end bell (49). Discard Iockwasher.

16 Remove two screws (50), two Iockwashers (51), and jumper wire (52). Discard Iockwashers.

b. Inspection, Repair, and Test

Compressed air used for cleaning purposes must not exceed 30 psi (207 kPa). Use

only with effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc).

1 Clean inlet screen (8) mesh with compressed air. Inspect mesh. Replace if torn.

2 Inspect impeller cover (9). Replace if damaged or defective.

3 Inspect impeller (1 2). Smooth burrs and nicks with soft stone or fine-mill file.

4 Inspect impeller housing (13). Replace if damaged or defective.

9-11

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 352 353

Comentarios a estos manuales

Sin comentarios

RHUB TM-510 Especificaciones Pagina 255

Comentarios a estos manuales