RHUB TM-510 Especificaciones descargar pdf (Pagina 190)

100

101

TM 9-2350-311-34-1

7-11 BULKHEAD-TO-DRIVER’S INSTRUMENT PANEL WIRING HARNESS — CONTINUED

Removal — Continued

14 Remove plastic strap (45), screw (46), and washer (47) to release wiring harness.

15 Remove 16 plastic straps (48), 16 screws (49), and 16 washers (50) (11 from left bulkhead and 5 from rear

bulkhead).

b. Disassembly

1 Remove electrical tape only for sections being disassembled.

2 Separate/isolate wiring harness.

3 Disassemble wiring harness (TM 9-2350-311-20-1).

c. Assembly

1 Assemble wiring harness (TM 9-2350-311-20-1).

2 Apply electrical tape only for sections being assembled.

d. Installation

1 Install 16 plastic straps (48), 16 screws (49), and 16 washers (50) (11 from left bulkhead and 5 from rear

bulkhead).

2 Install washer (47), screw (46), and plastic strap (45) to secure wiring harness.

3 Connect two connectors (16 and 17) to right taillight assembly (44).

4 Connect three connectors (16, 18, and 19) to left taillight assembly (43).

7-54

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 352 353

Comentarios a estos manuales

Sin comentarios

RHUB TM-510 Especificaciones Pagina 190

Comentarios a estos manuales